MP3383GF-P

Monolithic Power Systems (MPS)
946-MP3383GF-P
MP3383GF-P

メーカ:

詳細:
LED照明ドライバIC 4-String, Max 400mA/String, Max 80V Vout, Step-Up, WLED Controller

ECADモデル:
無料のライブラリローダーをダウンロードし、お使いのECADツール用にこのファイルを変換してください。ECADモデルの詳細について

在庫: 498

在庫:
498 すぐに出荷可能
最小: 1   倍数: 1
ユニット価格:
¥-
合計 額:
¥-
EST関税:

価格 (JPY)

数量 ユニット価格
合計 額
¥491.2 ¥491
¥369.6 ¥3,696
¥337.6 ¥8,440
¥304 ¥30,400
¥288 ¥72,000
完全リール(500の倍数で注文)
¥236.8 ¥118,400

製品属性 属性値 属性の選択
Monolithic Power Systems (MPS)
製品カテゴリー: LED照明ドライバIC
RoHS:  
4 Output
Buck
400 mA
TSSOP-16EP
33 V
6 V
500 kHz
80 V
MP3383
- 40 C
+ 125 C
PWM Dimming, Short Circuit and Thermal Protection
Reel
Cut Tape
ブランド: Monolithic Power Systems (MPS)
水分感度: Yes
取り付け様式: SMD/SMT
製品タイプ: LED Lighting Drivers
工場パックの数量: 500
サブカテゴリ: Driver ICs
製品が見つかりました:
類似製品を表示するには、チェックボックスを1つ以上選択します
このカテゴリーの類似製品を表示するには、上記のチェックボックスを1つ以上選択してください。
選択した属性: 0

CAHTS:
8542310000
USHTS:
8542310030
TARIC:
8542399000
ECCN:
EAR99

MP3383 Step-Up WLED Controllers

Monolithic Power Systems (MPS) MP3383 Step-Up WLED Controllers include four LED current channels. These controllers can expand the number of LED channels with two or more ICs in parallel sharing a single power source. The MP3383 WLED controllers employ peak current control mode with a fixed Switching Frequency (fSW) that is configurable through an external setting resistor. These controllers drive an external MOSFET to boost up the output voltage from a 6V to 33V input voltage (VIN) supply range.

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.