TPS61160DRVT

Texas Instruments
595-TPS61160DRVT
TPS61160DRVT

メーカ:

詳細:
LED照明ドライバIC White LED Driver A 5 95-TPS61160DRVR A 5 A 595-TPS61160DRVR

ECADモデル:
無料のライブラリローダーをダウンロードし、お使いのECADツール用にこのファイルを変換してください。ECADモデルの詳細について

在庫: 250

在庫:
250 すぐに出荷可能
工場リードタイム:
6 週間 表示されている時間を超える工場生産予定時間。
最小: 1   倍数: 1
ユニット価格:
¥-
合計 額:
¥-
EST関税:
パッケージング:
完全リール(250の倍数で注文)

価格 (JPY)

数量 ユニット価格
合計 額
カットテープ/ MouseReel™
¥254.4 ¥254
¥185.6 ¥1,856
¥169.6 ¥4,240
¥149.9 ¥14,990
完全リール(250の倍数で注文)
¥140.8 ¥35,200
¥132.8 ¥66,400
¥126.4 ¥126,400
¥122.7 ¥490,800
¥120.5 ¥964,000
† ¥750 MouseReel™の料金が追加され、ショッピングカートに加算されます。すべてのMouseReel™の注文は、キャンセルおよび返品できません。

他のパッケージ

メーカ 部品番号:
梱包:
Reel, Cut Tape, MouseReel
在庫状況:
在庫
価格:
¥216
最低:
1
メーカ 部品番号:
梱包:
Reel, Cut Tape, MouseReel
在庫状況:
在庫
価格:
¥218
最低:
1

類似製品

Texas Instruments TPS61160DRVR
Texas Instruments
LED照明ドライバIC White LED Driver A 5 95-TPS61160DRVT A 5 A 595-TPS61160DRVT

製品属性 属性値 属性の選択
Texas Instruments
製品カテゴリー: LED照明ドライバIC
RoHS:  
1 Output
Boost
700 mA
WSON-6
18 V
2.7 V
600 kHz
26 V
TPS61160
- 40 C
+ 85 C
PWM Dimming, Open LED Protection
Reel
Cut Tape
MouseReel
ブランド: Texas Instruments
高レベル出力電流: 100 uA
入力電圧: 2.7 V to 18 V
低レベル出力電流: 100 uA
水分感度: Yes
取り付け様式: SMD/SMT
チャンネル数: 1 Channel
出力タイプ: Current Mode
Pd - 電力損失: 1.54 W
製品タイプ: LED Lighting Drivers
工場パックの数量: 250
サブカテゴリ: Driver ICs
供給電流 - 最大: 1.8 mA
タイプ: Inductive
単位重量: 9.700 mg
製品が見つかりました:
類似製品を表示するには、チェックボックスを1つ以上選択します
このカテゴリーの類似製品を表示するには、上記のチェックボックスを1つ以上選択してください。
選択した属性: 0

この機能はJavaScriptを有効にすることが必要です。

JPHTS:
8542330996
CNHTS:
8542319090
CAHTS:
8542330000
USHTS:
8542390090
KRHTS:
8532331000
TARIC:
8542399000
MXHTS:
8542330299
ECCN:
EAR99

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.

TPS61160/1 White LED Drivers

Texas Instruments TPS61160/1 White LED Drivers have an integrated 40V switch FET with boost converters that drive-in series LEDs. Running at 600kHz fixed frequency, the boost converters reduce output ripple and enhanced conversion efficiency. This feature allows the usage of small external components. Feedback voltage is regulated to 200mV, and the external sensor resistor RSET is set through the default white LED. The LED current, while in operation, can be controlled using the one-wire digital interface (EasyScale protocol) through the CTRL pin. Applied to the CTRL pin, a pulse width modulation (PWM) signal the duty cycle determines the feedback reference voltage. The Texas Instruments TPS61160/1 will not burst the LED current in either digital or PWM mode. Additionally, this means that no audible noises will be generated on the output capacitor. Integrated open LED protection that disables the device prevents the output voltage from exceeding the device's absolute maximum voltage ratings during open LED conditions, offering maximum protection.