SparkFunアクセサリ This is a stainless steel Type-K Thermocouple probe. A thermocouple works by taking two wires made of dissimilar metals connecting them at the two ends and making a temperature gradient between one end and the other (a 'hot' end and a 'cold' one).

SparkFunアクセサリ High quality switching 'wall wart' AC to DC 9V 650mA wall power supply manufactured specifically for Spark Fun Electronics. These are switch mode power supplies which mean the output is regulated to 9V (no more 14V outputs!) and the capable output cu

SparkFunアクセサリ This is an adapter that converts an RP-SMA board to an SMA antenna. The adapter will connect to any of our 2.4GHz wireless boards (Bluetooth Nordic or XBee) or interface cables and will allow you to use an antenna/cable with an SMA connection. You

SparkFunアクセサリ This high-gain duck antenna is designed for LTE devices that operate in the 690-960MHz and 1710-2690 MHz bands. Combined with an SMA to U.FL Adapter this duck antenna works perfectly with our LTE Cat M1/NB-IoT Shield.

SparkFunアクセサリ This is a simple SPDT slide switch - great for use as an ON/OFF button or just as a general control switch. The pins are spaced by 0.1" however they are incredibly thin making breadboard use not recommended. The switch is rated for 0.3A at 50VDC.

SparkFunアクセサリ Thermoelectric coolers (TEC or Peltier) create a temperature differential on each side. One side gets hot and the other side gets cool. Therefore they can be used to either warm something up or cool something down depending on which side you use. Y

SparkFunアクセサリ Power Resistor Kit 10W (25 pack)

SparkFunアクセサリ Through-hole RJ11 socket with PCB mounting posts. 6-pin connection - housing accepts common telephone connectors/wiring.If you need a board for this connector be sure to check out our SparkFun RJ11 Breakout. Two boards are included so be sure to buy

SparkFunアクセサリ Single row of 30-holes female header with swiss round machined pins. These units have very high quality round pins to accept and retain machine pin headers much better. Can be cut to size with a pair of wire-cutters. Standard .1" spacing. We use the

SparkFunアクセサリ This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin Molex connector with 0.1" spacing on one end bare cable on the opposite end. It also comes with the mating connector for the Molex.D

SparkFunアクセサリ DC Barrel Power Jack Connector SMD

SparkFunアクセサリ These are simple 6-position screw terminals with 2.54mm pitch pins. Rated up to 150V @ 6A this terminal can accept 30 to 18AWG wire. The 2.54mm pitch will line up with standard 0.1" perf boards.