すべての結果 (1,945)

SparkFunアクセサリ This is a black plastic bezel custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. We use four 4/40-0.5" size screws matched with plastic standoffs to attach the 2x2 button pad and Simon project boards. Using two of these bezels

SparkFunアクセサリ Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft diffuse glow.Features:587-591nm Yellow1.8-2.2VDC Forward Voltage20mA Forward Current40 degree viewing angle100-150 MCD outputDocuments:[Datasheet](

SparkFunアクセサリ USB Type 'A' Male connector. Ideal for making very small USB dongle devices that plug directly into a computer USB port or through a USB AtoA extension cable.Documents: Datasheet

SparkFunアクセサリ This red Mini Breadboard is a great way to prototype your small projects! With 170 tie points there's just enough room to build and test simple circuits; They're also great for breaking out DIP package ICs to jumper wires! If you run out of room no

SparkFunアクセサリ Photo interrupter photogate photodiode phototransistor whatever you want to call it this sensor is composed of an infrared emitter on one upright and a shielded infrared detector on the other. By emitting a beam of infrared light from one uprigh

SparkFunアクセサリ These are very small surface mount quartz crystals used where size is a concern. Ideal for use with the nRF2401 ICs. 20ppm * 18pF load capacitance

SparkFunアクセサリ LEDs - those blinky things. A must have for power indication pin status opto-electronic sensors and fun blinky displays.This is a very basic 5mm LED with a red lens. It has a typical forward voltage of 2.0V and a rated forward current of 20mA.

SparkFunアクセサリ For a long time we've had small 7-segment displays and *huge *7-segment displays but now we finally have something in between. These 20mm 4-digit 7-segment displays are big enough to see from a distance but not so big that you'd have trouble finding

SparkFunアクセサリ Screw Terminals 3.5mm Pitch (2-Pin)

SparkFunアクセサリ Polarized connectors and headers for your perf board/PCB projects. Use these connectors for power connections or any sensor/general connection to prevent users from connecting the peripheral incorrectly or reversed.This is for the male header. Be sur

SparkFunアクセサリ This 4-pin ATX right angle connector mates up to the standard 4-pin computer peripheral port often found on ATX power supplies. This connector will also serve as a replacement to that found in the SparkFun ATX Power Connector Breakout Kit.

SparkFunアクセサリ This is an inner thread (outer nut) adapter that will connect to any of our wireless boards or interface cables and allow you to use an antenna/cable that has an outer thread configuration. You should not need this adapter with any of our antennas or