すべての結果 (1,921)

SparkFunアクセサリ A small audio speaker that is ideal for radio and amplifier projects and is small enough to fit in robot projects.

SparkFunアクセサリ This is the kind of 1/4" stereo jack you might find in home stereos and PA systems. Switched contacts allow you to detect whether or not there is something plugged in to the jack. The jack can be panel mounted in an 11mm diameter hole. The jack comes

SparkFunアクセサリ This is a simple knob that connects to the small and medium sized linear slide potentiometers. Each knob uses friction to secure itself to fit onto the slide pot. Once attached this small knob provides you with an easier to use potentiometer for you

SparkFunアクセサリ Polarized connectors and headers for your perf board/PCB projects. Use these connectors for power connections or any sensor/general connection to prevent users from connecting the peripheral incorrectly or reversed.This is for a pack of 20 individual

SparkFunアクセサリ This 4-pin ATX right angle connector mates up to the standard 4-pin computer peripheral port often found on ATX power supplies. This connector will also serve as a replacement to that found in the SparkFun ATX Power Connector Breakout Kit.

SparkFunアクセサリ This is an inner thread (outer nut) adapter that will connect to any of our wireless boards or interface cables and allow you to use an antenna/cable that has an outer thread configuration. You should not need this adapter with any of our antennas or

SparkFunアクセサリ This is a 1A Adjustable SOT-223 voltage regulator capable of outputting 1.2V to 18V. The LM1117 uses the same pin-out and setup as the popular LM317 adjustable regulator contained in a handy surface mount package. Requires two external resistors to

SparkFunアクセサリ This is a simple knob that connects to the extra large sized linear slide potentiometer. Each knob uses friction to secure itself to fit onto the slide pot. Once attached this small knob provides you with an easier to use potentiometer for your proj

SparkFunアクセサリ LED - SMD RGB

SparkFunアクセサリ 1.0M Ohm 1/4th Watt +/- 5% tolerance PTH resistors. Commonly used in breadboards and perf boards. We've opted for a new and more breadboard-friendly lead thickness (they're a bit thicker than our last ones).Note: Sold as singles. But check below fo

SparkFunアクセサリ USB Type 'A' Female SMD connector. For use with any PCB that will be used with a Type A to Type A USB cable. Designed to mount to the UBW32.Documents:Datasheet

SparkFunアクセサリ This is the SMD version of PRT-07948 which is the unit we like to use as RTC backup and SRAM backup for GPS units. Holds battery in place with friction. The metal housing connects to the positive side of the battery and the PCB pad underneath is con