すべての結果 (1,945)

SparkFunアクセサリ These are bare non-addressable 1 meter long RGB LED strips that come packed with 60 5060 LEDs per meter. As these are bare LED strips that have no protective coating your project won't be water proof but there is access to each 5060 LED and each str

SparkFunアクセサリ The SparkFun Qwiic Dual Solid State Relay is a power delivery board that allows users to switch two AC loads from a low power microcontroller using the SparkFun Qwiic connect system. The board features two 25A/250VAC solid state relays that utilize t

SparkFunアクセサリ The name says it all on this one. An ATmega328 in DIP package pre-loaded with the Arduino Optiboot (Uno 16MHz) Bootloader. This will allow you to use Arduino code in your custom embedded project without having to use an actual Arduino board.To get t

SparkFunアクセサリ The MicroMod Machine Learning Carrier Board combines some of the features of our SparkFun Edge Board and SparkFun Artemis boards but allows you the freedom to explore with any processor in the MicroMod lineup without the need for a central computer

SparkFunアクセサリ The SparkFun Inventor's Kit (SIK) has been and continues to be a staple for classrooms workshops and makerspaces for over 15 years. But when many hands share the same hardware over a semester small components inevitably get lost or broken. Instead

SparkFunアクセサリ Standard 22 AWG solid Brown hook up wire. Use this with your bread board or any project in which you need sturdy wire. Comes in small spools of 25'.

SparkFunアクセサリ This is a simple 4 cell AA battery holder. The 5 inch cable is terminated with a standard 5.5x2.1mm center positive barrel jack connector.The connector mates with the barrel jack on the Arduino (among a number of other products) allowing you to easi

SparkFunアクセサリ This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.Dimensions: 6" lengthDocuments

SparkFunアクセサリ This is a simple six wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.Dimensions: 6" lengthDocuments:D

SparkFunアクセサリ 6-Pin Chassis Connect Panel Mount

SparkFunアクセサリ Jumper wires are awesome. Just a little bit of stranded core wire with a nice solid female connector on either end. They have the flexibility of stranded wire but will fit directly onto male pin headers. The only downside to the standard jumper wires

SparkFunアクセサリ This is a SMD 4-pin right angle male header. We use this header on our Graphic LCD Serial Backpack.Pins have 0.1" spacing between rows and between pins.Documents:Dimensional Drawing