すべての結果 (1,921)

SparkFunアクセサリ This is a simple cable that adapts from a USB port to a 5.5x2.1mm barrel connector center positive. This cable allows the user to use a USB port on a computer laptop or on our cigarette power supply to provide our development boards with 5V.The US

SparkFunアクセサリ These are your standard issue USB 2.0 type A to micro USB 5-pin... but wait what's this? These cables have minor yet genius modifications that allow both ends to be plugged into their ports regardless of their orientation. No longer will you fight

SparkFunアクセサリ The QRE1113 is a small IR reflectance sensor. This sensor is often used in line following robots because if it can sense if a surface is white or black.There are four pins on the QRE1113 - two control the IR emitting LED while the other two are the

SparkFunアクセサリ This is a simple LED-illuminated tactile button with a green cap. It's just like a basic tactile button but it lights up green! So now you can get visual feedback or light up your project. These have a 12mm body and are rated for 50mA. They don't e

SparkFunアクセサリ This little round on/off toggle switch is rated up to 10A at 125VAC and can be panel mounted in a 20mm diameter hole. It'll also look pretty slick in your project.

SparkFunアクセサリ Cherry MX Keyswitches are recognized worldwide as a benchmark for mechanical keyboards trusted by gamers and programmers alike for their exceptional feel and tens of millions of press cycles. This specific "blue" switch (MX1A-E1NW) delivers a highly

SparkFunアクセサリ Screw Terminals 5mm Pitch (3-Pin)

SparkFunアクセサリ This is a right-angle 24-pin Molex Mini-Fit Jr. connector commonly used as the power supply connector on ATX motherboards. Two rows of twelve pins are broken out two rows of through-hole male headers. See the datasheet below for pin spacing dime

SparkFunアクセサリ This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST connector on one end bare cable on the opposite end. It also comes with the mating connector for the JST.

SparkFunアクセサリ Copper tape has countless applications in electronics from creating low-profile traces for electrical components to RF-shielding and antenna-making. Copper tape is even used to join things together using solder like the stained glass on Tiffany lamp

SparkFunアクセサリ This is a 2x23 pin male PTH header. This piece is in the common configuration for Beaglebone Black headers that can be broken apart to form smaller header formations. Each pin has a spacing of 0.1" in between each other.Documents:Datasheet

SparkFunアクセサリ These needle tipped multimeter probes are great for attaching to multimeters power supplies oscilloscopes function generators etc. Not only can these make a good replacement for any multimeter probes you have now that are damaged or worn but tha