Digilent Arty S7™ FPGA Board

Digilent Arty S7™ FPGA Board is a member of the Arty development board family and features the Xilinx Spartan-7 FPGA. The Spartan-7 FPGA is fully compatible with Vivado Design Suite and offers the most size, performance, and cost-conscious design engineered with the latest technologies from Xilinx.

The FPGA in housed in the Arty form factor for use with a wide variety of I/O and expansion options. The dual row Arduino® connectors can be used to mount one of the hundreds of hardware compatible Arduino Shields. Pmod ports can also be used with Digilent's pre-made Pmod IP blocks for a more streamlined design experience. Arty S7 was designed to be MicroBlaze ready and is ready to use with the free Xilinx WebPack version of Vivado Design Suite.

Features

Xilinx Spartan-7 50 FPGA (xc7s50csga324-1)
- 8,150 slices (each slice contains four 6-input LUTs and 8 flip-flops)
- 2,700 Kbits of fast block RAM
- Five clock management tiles, each with a phase-locked loop (PLL)
- 120 DSP slices
- Internal clock speeds exceeding 450MHz
- On-chip analog-to-digital converter (XADC)
- Programmable over JTAG and Quad-SPI Flash
Memory
- 256MB DDR3L with a 16-bit bus @ 650MHz
- 16MB Quad-SPI Flash
Power
- Powered from USB or any 7V-15V external power source

USB
- USB-JTAG Programming circuitry
- USB-UART Bridge
Switches, Push-buttons, and LEDs
- 4 Switches
- 4 Buttons
- 1 Reset Button
- 4 LEDs
- 2 RGB LEDs
Expansion Connectors
- 4 Pmod ports
  - 32 total FPGA I/O (16 shared with shield connector)
Arduino/chipKIT Shield connector
- 45 total FPGA I/O (16 shared with Pmod connectors)
- 6 Single-ended 0-3.3V Analog inputs to XADC
- 3 Differential 0-1.0V Analog input pairs to XADC