すべての結果 (1,704)

SparkFunアクセサリ This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end bare cable on the opposite end.Dimensions: 130mm lengthDocuments:JST connector

SparkFunアクセサリ This barrel jack plug is great for adding a common connector to the end of our wires. This jack is compatible with 5.5mm barrel jacks that have a 2.1mm center pole diameter. The outer shell unscrews to reveal solder terminals and a crimp strain relie

SparkFunアクセサリ Copper tape has countless applications in electronics from creating low-profile traces for electrical components to RF-shielding and antenna-making. Copper tape is even used to join things together using solder like the stained glass on Tiffany lamp

SparkFunアクセサリ Piezo Element

オプティカルセンサ開発ツール A simple breakout PCB for the GP1A57HR photo interrupter (also known as a photogate photodiode or phototransistor). This PCB has three connections for PWR GND and Signal.When the gate is clear SIG will be high (>4.9V). When the gate is blocked b

教育ロボットキット Do you have some liquids that you need to move? This fluid pump will move 350 gallons per hour! The SEAFLO mini water pump has a heavy duty 12V 1.5Amp motor and a tough thermoplastic body. It's totally submersible and water-cooled (but it won't burn

アンテナ開発ツール This is the Antenna Kit for the Raspberry Pi 4 Compute Module wireless variants. The duck style antenna adds range to the wireless radio on the wireless enabled Compute Modules. Something quite desirable if you re working in industrial enviro

マグネチックスイッチ/リードスイッチ This is a small device called a reed switch. When the device is exposed to a magnetic field the two ferrous materials inside the switch pull together and the switch closes. When the magnetic field is removed the reeds separate and the switch opens.

SparkFunアクセサリ This USB 2.0 Type-C cable is perfect for use with your Raspberry Pi 4 and other USB Type C boards. USB Type-C Connectors and Cable Assemblies offer greater PCB savings while enabling high-frequency mating in data consumer and other I/O applications

Raspberry Pi HAT / アドオンボード Feeling fancy? Why not add a Top pHAT to your Pi pHAT stack? The SparkFun Top pHAT for Raspberry Pi is intended to be at the top of a pHAT stack so you won't find any pins for stacking on top of this board but that's ok because you will want to pre

NFC/RFIDタグとトランスポンダ This is a basic RFID tag that functions within the MIFARE Classic 1K guidelines. You can use these for all sorts of identification and sensing applications. The tag also has 1K of data storage which can be read and written from a compatible device.

NFC/RFID開発ツール RFID Tag (125kHz)